Our Services
Well Pump Replacement in Wenatchee, WA
When your pump is done, you need water back fast. We size, supply, and install quality replacement pumps across the Wenatchee Valley, usually the same day.
When your pump is done, you need water back fast. We size, supply, and install quality replacement pumps across the Wenatchee Valley, usually the same day.
If you're looking at well pump replacement in Wenatchee, you're probably already dealing with weak pressure, a pump that won't shut off, or no water at all. Most pumps in our area last 10 to 15 years, and when they go, they rarely give much warning. We've replaced hundreds of pumps from Cashmere to Quincy, and we can usually tell you within an hour whether yours is worth saving or due for swap-out.
A typical replacement runs $1,500 to $4,500 installed, depending on your well depth and the pump you need. That's the full job: pulling the old pump, new wire and fittings, the right pump for your flow and depth, and testing the whole system before we leave. If the well quit on you tonight, our 24/7 emergency well service covers that too. Call (509) 224-3484 for a free estimate.
We stock common submersible pumps for the well depths we see most around Wenatchee. In most cases your water is back on the same day we pull the old pump.
If a $400 repair will get you another five years, we'll tell you. We only push replacement when the math actually favors it.
We match pump GPM and horsepower to your well's depth, recovery rate, and household demand. An oversized pump burns out early, and an undersized one starves your fixtures.
Grundfos, Goulds, and Franklin Electric pumps with real manufacturer warranties. No bargain-bin units that fail in three summers.
You get a written quote before we pull anything. Most Wenatchee replacements land between $1,500 and $4,500 installed, and we'll show you exactly where yours falls.
Free estimates, clean work, and a crew that's been pulling pumps in Chelan, Douglas, and Grant counties for years.
Not every dead pump needs replacing. A bad pressure switch, a waterlogged tank, or a tripped breaker can mimic pump failure, and those are cheap fixes. That's why we always diagnose first. Our well pump repair service handles the stuff that doesn't require pulling the pump.
Replacement starts making sense in a few clear situations. If your pump is past 10 years old and the motor itself has failed, putting money into it is usually throwing good after bad. Same story if the repair quote crosses about half the cost of a new pump installed.
We'll walk you through the numbers on site. If repair wins, we repair. If replacement wins, we'll quote it on the spot, and you can see how it compares to typical well pump costs in our area.
Most wells in the Wenatchee Valley run submersible pumps, and for good reason. A submersible sits down in the well below the water line, pushing water up instead of pulling it. They're quieter, more efficient, and they handle the 100 to 400 foot wells common on orchard and rural properties around here.
Jet pumps sit above ground, usually in a pump house or basement, and pull water up by suction. A shallow well jet pump works to about 25 feet, and a deep well jet setup can stretch to around 100 feet. They're easier to service since nothing has to come out of the well, but they're less efficient and they're vulnerable to freezing in our winters if the pump house isn't heated.
If you've got an older jet pump on a deeper well, upgrading to a submersible during replacement often pays for itself in power savings and reliability. We'll look at your well log, your depth to water, and your existing plumbing, then give you a straight recommendation. No upselling, just what fits your well.
Pump sizing is where a lot of installs go wrong. The right pump matches three things: how much water your household uses at peak, how deep your water sits, and how fast your well recovers. Get any of those wrong and you'll either starve your sprinklers or burn out a motor that short-cycles all day.
For flow, the rule of thumb is 1 gallon per minute per fixture. A typical 3 bedroom, 2 bath home in East Wenatchee needs a 8 to 12 GPM pump. Add irrigation for a big lawn or a few acres of trees and you may need 15 to 25 GPM, assuming the well can deliver it.
Depth drives horsepower. A 10 GPM pump set at 100 feet might only need 1/2 HP, while the same flow from 400 feet can take 1.5 HP or more. We check the well log, measure static water level, and size from real numbers, not guesses. We'll also check your pressure tank while we're at it, because a new pump paired with a failed tank won't last.
A standard residential replacement takes most of a day, and your water is usually back on before dinner. Here's how it goes.
Every install comes with the manufacturer warranty plus our workmanship guarantee. We serve the whole valley, including East Wenatchee, Cashmere, Leavenworth, Lake Chelan, Quincy, and Moses Lake.
Most replacements run $1,500 to $4,500 installed. A shallow well jet pump swap sits at the low end, while a 1.5 HP submersible in a 300 to 400 foot well with new wire lands at the high end. We give written quotes before any work starts, and estimates are always free.
Plan on 10 to 15 years for a quality submersible pump that's sized correctly. Sandy water, frequent cycling from a bad pressure tank, or an undersized pump can cut that to 5 to 8 years. If yours is past the 10 year mark and acting up, it's worth a hard look before you sink repair money into it.
Most jobs take 4 to 8 hours, and you'll only be without water while we work. We stock common pump sizes, so same-day replacement is the norm rather than the exception. If you've got no water right now, call (509) 224-3484 and we'll get a tech moving.
If your water sits deeper than about 25 feet, usually yes. Submersibles are more efficient, quieter, and they don't freeze in an unheated pump house in January. The upgrade adds a few hundred dollars to the job in most cases, and many homeowners earn that back in lower power bills within a few years.
We install Grundfos, Goulds, and Franklin Electric, the three names with the best track record in North Central Washington wells. Manufacturer warranties typically run 3 to 5 years depending on the model. We don't install no-name pumps, because saving $200 up front isn't worth pulling the well again in three summers.
Free written estimates. Emergency no-water calls answered around the clock.
